Super simple method for extracting 2cb powder out of pills : Psychedelics | Torhoo darknet markets

I didn't find much information on this, so I wanted to share my results from trying to extract 2cb powder from a pill. I was able to extract about 13mg of white powder from a pill with a 24mg stamp.

This resulting powder was confirmed to be psychoactive at expected levels. And the 13mg seems to be approximately the amount of 2cb in the pill without extraction. So very little was lost in the extraction process.

(Note: This may not work if there are water soluble fillers used and/or due to other reasons. This is just a complete amateur experiment which happened to work for me)

Here is the short instruction. Feel free to ask for more specific instructions if needed.
You will need:
-A reagent tested 2cb pill
-Syringe without needle (1ml)
-Cotton ball (from a q-tip for example)
-Metal spoon
-Hot water
-Heat source
-A shotglass

Dissolve and mix pill in 1ml warm/hot water in a container (shotglass is perfect). Make sure the pill completely disintegrates in the water, mix it thoroughly and let it sit for a couple minutes.

Use a cotton ball to filter through into a syringe. You can wet the cotton ball first with water to avoid it absorbing too much of the 2cb liquid. The resulting liquid should be clear and the 2cb should now be in the water solution. (Don't dispose of the leftover pill goo yet, you can do a second and third extraction from it later.)

Now place the solution on metal spoon. Heat the spoon from underneath on a stove (or with a lighter) to speed evaporation. Be careful if it boils to avoid spills. When you see all the liquid has evaporated, remove it from the heat source.

Use a butter knife or some other object to scrape resulting white powder from the spoon. Weigh the powder to see if the amount is as expected. Do another extraction on the leftover filler, you may get still more out of it. Even a third round still got me a few mg more out. But that should be enough :)


Snort away! Or boof it <3