Washing SPEED with ACETONE : TheGoodSpeedGuide | Torhoo darknet markets
Hi guys, I have some doubts about washing my speed. I'm able to get anhydrous acetone. I'm not an chemistry expert at all, the things I know are just by reading forums, and some chemistry books.
I get this info from (The Merck Index 14th Edition):
*Amphetamine sulfate solubility: (Temperature at 25ºC)
Freely soluble in water (1:9)
Slightly soluble in alcohols (1:500)
Very slightly soluble in acetone (1:970)
*Caffeine:
One gram dissolves in:
-Polar solvents-
50 ml acetone
So getting that info I will add to the (previously dried paste) amp. 50 ml of acetone per each gram I get.
These are the steps I think are the ones to follow
1. Let the paste dry.
2. Put the powder into a glass
3. Add per each gram of dry amp 50 ml of anhydrous acetone.
4. Stir for a minute or so until all dissolved
5. Let the glass repose for around 5 minutes so it will decant the good stuff and the majority of the cutting agents, like caffeine should be already dissolved and mixed with the acetone.
6. Carefully with a syringe extract all the remaining acetone and put it into a second glass.
7. Wait until all the content of the first glass dried, or put all the content in a plate to speed up the process of drying.
8. Repeat all the above steps 2 more times if need it or until observe a more clear and transparent acetone on top after waited the 5 minutes in the decantation process.
I know there is other way by filtering using coffee filter N°4 (the brown ones one can get in Amazon) but I read I will loss some part of the good stuff in stuck in the micro pores the same filter . And if I need to repeat the process 2-3 times will be losing what I not want to be loss, even if it's not much.
I just want to know if there is any suggestion/recommendation on the 8 steps above. Thx
1.1) Step 7 wont required except for the case you´ll change the solvent in the next step 3.
2) if you go to wash 5g, 10g, 20g put it after step 4 in the filer (coffee or lab). When the acetone is completely went through the filter, add some new, WITHOUT changing the filter and DON´T let it dry before. REPEAT to rinse it 2-3 times. After the last acetone is went through the filter take the filter and put it between paper towels and press the all left over acetone out. then let it dry in the filter. the amount who do stuck in the filter is max 0,1-0,15g. (you can weight the filter before and after the wash to be sure).
filter and rinse is always best way, imo.
stay upper
Did you find any difference from that method to waiting it to dry it, and putting the powder again in the glass, then stir it and repeat the process with the acetone and filter it? besides the time I will gain doing it via that way you said.
Thanks
recommended by a chemist, yep. why think you have to dry the speed after each wash?
Only when your solvent changes for example from DCM to acetone (maybe this is not needed too, ive just read anywhere).
The difference is that you have you speed clean in 30 min, and not in 3 days xD
you can stir in the filter too with a lab glass stick (not like in a glass but it does make no sense). Important is when you start the wash first time the powder must be completely dry and as fine as possible.
its the best way to clean your speed, like rain water who solve important and healthy minerals when it went through a mountain and on the bottom is a water spring with that very nice water. in our case we solve the crap in our mountain and clean the speed ;)